Moai Piggy Bank - Remix

First of all: all the credits for this beautiful model goes to ET-Huang (https://www.thingiverse.com/thing:144668) and Julien_DaCosta (https://www.thingiverse.com/thing:2493386, who remixed it for no overhang).

In a attempt to increase my skills in Meshmixer and 3d-Builder* I remixed the statue of ET-Huang / Julian DaCosta to a piggy bank. I created the used fill-opening with screw-cap some time ago .(https://www.printables.com/model/272261).

The model is 200 mm high. The wall thickness is 3 mm, except for the bottom where it is 18 mm to make it flat with the fill opening. The vertical opening at the top is 35x3.5 mm.

You have to see the make of CiscoKEB, who printed a beautiful one in white Marble filament.

Happy saving :)

The Spongebob version (Squidwards house) can be found here: https://www.printables.com/model/272210

*Although I was able to create this thing in both programs, the result of the Hollow-function in Meshmixer was a lot better (see picture). On the other hand i had to repair that stl in 3d-builder before it successfully sliced (slic3r). 3d Builder turns out to be a very good STL-repair-tool.

Print Settings

Printer Brand:

Anycubic

Printer: 

Kossel

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

15% but 10% is Ok

Filament: Owl PLA Orange

Notes:

The print tooks about 15 hour. 235 grams of filament used with 15% infill and 3 walls/perimeters of 0.4 mm

Category: Sculptures