September 12, 2022
Description
Designed for two Kabuflex R40 pipes that I have placed in the earth from my house to the garage. The cable entry shall protect the two pipes from water and dust and is the point where the cables enter the garage.
With my printer settings (see below) it took me about 13 hours to print this design. If you want to print it, rotate the design by 180 degrees and enable support for the screw mounts.
Printing:
I used white PETG, no supports, 30% infill, 0.2mm with my Creality CR6SE.
Printer:
Creality CR 6 SE
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
30
Filament:
Material4Print PETGwhite
Notes:
Rotate the design by 180 degress so that the top of it is printed first.
License:
Creative Commons — Attribution — Share Alike
Octoate
