Parallel Gripper for EEZYbotARM MK2

This is a remix of my Rov Manipulator (Parallel Gripper) modified to fit the EEZYbotARM MK2 robotic arm and be controlled by a servo instead of a rotating shaft.

Use a SG90 Servo

Hardware required (See pictures for screw layout.) All screw holes are pre-tapped

(4) 2-56 x 1/2" screws

(2) 4-40" x 3/8" Button Head Screws

(2) 4-40 x 1" Flat Head Screws

Servo Mounting screws.

Some of the parts will need to be oriented to be printed properly. See pictures for the layout I used. The fingers, forward hinges, and Pad need to be printed x 2. The finger pads were printed in a flexible filament for better grip but can be cut from rubber.

See https://www.theneverendingprojectslist.com/raspberrypiprojects/raspberrypiroboticarm/ for more info.

Category: Robotics