September 22, 2022
Description
I have got myself an iPhone 14 Pro. Naturally I need to make this, just like 2 years ago ;)
I added two cat ears to make sure when set on a flat surface, the cameras will have a 0.5mm clearance, and the entire phone doesn't teeter-totter XD
----------------------
To install, fit the top two corners in first, then one of the bottom corner, then force the last corner and push it in. It's a snap-in design so you have to force it.
----------------------
In order to successfully print this one, here are some of my suggested slicer settings:
The support settings is to make sure the support is easy to remove, still retains its integrity, while prints relatively fast. Otherwise with a support that's too strong, you risk damaging the print itself.
Make sure the long sides are on the less-ripply side of your printer, unless you wanna see more ripples on a big surface every day.
License:
Creative Commons — Attribution — Share Alike
Jeff Chen
