September 21, 2022
Description
Remixed https://www.thingiverse.com/thing:4601328 with legs added to clip onto the middle of the sink. My sink was around 30mm at the top and gently sloped outwards, designed this with the legs straight down so they flex slightly and grip onto the sink.
Printer:
Artillery Sidewinder X1
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
25%
Filament:
Hatchbox PLABlack
Notes:
Print on its side and you shouldn't need supports. Will probably need a brim unless you're confident in your build plate adhesion. I used hairspray with no brim and it stuck until the very final layer. Would use a brim if I printed again.
License:
Creative Commons — Attribution
Wheesir
