IKEA ENHET Endstop

I always manage to push things off shelves and break them. These simple end stops put an end to that (no pun intended) and prevent things from falling off the sides of the IKEA® ENHET shelf.

Print Instructions

Use the provided STEP or STL files to print your end stop. Print with the flat side oriented down and please make sure to turn on supports. 

• Layer height ≥ 0.2 mm
• Support enabled
• Should work with all common (sturdy) filament types. I used PLA. 

Assembly

Just insert at an angle and gently push down until it sits at the bottom of the shelf.