SKADIS caliper holder with battery shelf

FIRST THING FIRST

This model use the universal hook from CSD_Salzburg (Thingiverse)
https://www.thingiverse.com/thing:2853261

THIS IS One of the best setup for SKADIS for thoses reasons:
- Most of the thing print without support
- the hook are printed separately and flat (so it's MUCH stronger with this orientation)
- When you want to take your tool, the holder don't come with it since it's a tight fit.

The hook from CSD_Salzburg is in the files too.

Those cheap caliper are very handy for 3D printing, but they are cheap… if you keep the battery inside, it will always drain it. this is why I always remove the battery from the tool.

Printing Informations

• Print flat without support
• you can add a brim if you want
• 30% infill
• 3 or 4 perimeters

Installation Informations

• First, check the fit of the hook in the rectangle holes. You may need to file a little bit to fit the hook. (If Elephant foot)
• Install the 2 hooks on the Skadis board and insert the holder (Like in the pictures)