Aixun T3A Solder Station Stand

Designed to be printed @ 0.2mm layer height with 0.4mm nozzle.

I really like my new Aixun T3A solder station but the only small negative, if you can really call it that, is the fact that the unit sits flat on a desk and makes reading the screen a little more difficult than it could be.

This is why I printed basic wedge just to raise the front of the unit up a little.

I have also added slightly recessed areas for the units original rubber pads to locate for stability (hopefully they are consistent across all units).

I would also suggest adding some rubber pads to the base of the wedge to stop possible sliding around.

Happy Printing ;)

Category: Electronics