Mini Laser Engraver Upgrade Parts

These are the 3D printed part designs that go with my Instructable, Making Your Mini Laser Engraver Safer And Better. They are designed to be used with any of the SuperCarver-style "Laser Engraver Printer Cutter Carver DIY Engraving Machine" units commonly sold for between $80 and $150, and I have applied them to a 1000mW @ 405nm unit branded HTPOW. See the after and before photos above. Here is a video from the webcam I placed inside the engraver -- it is not sped-up; this is the actual engrave speed.

These machines have the potential to very quickly cause significant harm. I'm not an expert in the law, nor in laser safety; I'm just a maker who sees the potential, both good and bad, of these little engravers.You bear all responsibility for safe configuration and operation of your laser. I'm just describing what I did to my machine in an attempt toreduce the risk and improve functionality.

Print Settings

Printer Brand:

MakerGear

Printer:

Rafts:

No

Supports:

Resolution:

0.25mm

Infill:

Notes:

These parts are easy to print, but material choice is very important.Print them in PLA. Why? PLA behaves much better than most plastics when hit by a laser; especially avoid any chlorinated plastics, but also avoid ABS because the gas produced if it gets hit by the laser is pretty nasty. The color of the material also matters; enclosure parts need to be opaque to the laser light, and the jigs should be made of a color that minimizes scattering of the laser light.

Post-Printing

Read my Instructable to understand how these 3D-printed parts are intended to be used; also read other materials so that you can understand the dangers and safely operate your laser.Avoid the temptation to try things first and read instructions after a serious problem has surfaced:I didn't even plug-in my laser's power supply until after I had built an enclosure for the unit.

How I Designed This

These parts were all designed using OpenSCAD. I might post a Customizer version once I'm sure the design will not change for a while -- for example, I'm still looking at alternative methods to make the vent filtering more effective.

Category: Parts