Wiha Convertible Screwdriver Skadis Pegboard/Freestanding Holder

Details

This is a Wiha screwdriver holder I designed to lock onto a French Cleat on your Ikea Skadis pegboard, or with the push of two buttons, can be removed to stand freely on two legs that fold into the sides. 

For the pushbuttons I used springs 8mm in diameter and about 8mm long that I had laying around, and screws from an old hard drive that are 2-56 by about a half inch long.  These are screwed into a heat set insert melted into the pushbutton.  

This model also uses T-Nuts for Ikea Skadis Pegboards by user 6d6178 to attach to the Skadis.  The hardware for that is included below, but you'll have to download the models from them.

It needs the following heat set inserts

QTY 2 - 2-56

QTY 2 - M3

QTY 6 - M2.5

It needs the following hardware

QTY 6 - M2.5 x 12mm screws

QTY 2 - M2.5 x 25mm screws (for the T-Nut)

QTY 2 - M3 x 10mm screws

QTY 4 - M2.5 Washers

QTY 2 - M2.5 Nuts (for the T-Nut)

It uses three 6x3mm magnets to hold the screwdriver kit.  

I've included the step file so you can customize the middle support plate if you want.

Print Instructions

I printed in PLA at .1mm layer heights and supports where needed.