July 1, 2023
Description
A fast printing vase mode desiccant container 50x50mm to fit inside of the spool center during storage.
Less than 10 grams filament is needed and prints fast.
Recommended to be printed with PETG (without partcooling) for strength and flexibility.
On my Ender 3 v2, using a 0.6mm nozzle & PETG, container and lid were printed in less than 40 minutes total.
Slicer recommendations:
The holes in the bottom/lid are 1mm deep, adjust the bottom thickness in the slicer accordingly and check the gcode preview.
Use spiral/vase mode to print.
A wall thickness of at least 0.6mm is advised for strength (can also be printed with 0.4mm nozzle).
It is remixed from a nice redesign from brettvitaz.
The model is enlarged to 50x50mm and the holes in the top and the lid are replaced by a square grid to minimize the amount of retractions needed.
License:
Creative Commons — Attribution
7
JW693D
