BTT Octopus V1.0 & V1.1 Electronics Remix

I liked the case made by twhite0101 but edited three parts of the motherboard-only version of his design. I included the other pieces you will need to make it a full case but credit for the original design goes to twhite0101.

1. BTT_Octopus_front

The ports did not line up with my board so I edited it until they fit and added a bit more bevel around the SD card slot, USB-C connector, and reset button.

1. BTT_Octopus_rear

I opened it up so you have more straightforward access to the power connections

1. BTT_Octopus_top_Board_Only

I wanted to use a 60mm fan I had on hand plus the top lacked the flair the rest of the case had so I added in the hex pattern from the other pieces.

You can print this at any resolution and it does not need supports.

Print Settings

Rafts:

No

Supports:

Resolution:

any

Infill:

Filament: any any

Category: 3D Printing