Brno University of Technology Coaster

Brno University of Technology/Vysoké učení technické v Brně Coaster  

Print was designed to be dual-colour with colour change aproximately on 2.00mm height. Height of change depends on your preferred layer height, but last layer of inner “T” ( white part) is set to be at 1.8mm( this height was used intentionally as it is mutual layer for 0.10, 0.15 and also 0.20mm layer height). Overall height of print is 3.6mm(dimensions of whole coaster are 100x100x3.6mm). 

I recommend using PETG instead of PLA (or any more thermal resistant material if you intend to put hot drinks on it - you know, just to be sure, accidents happen). Both filaments I used were Devil Design PETG.

Included .gcode is in default 0.15mm QUALITY profile from PrusaSlicer with Devil Design PETG preset.

This project was printed @ FabLab Brno.

All logo copyright rights are reserved by Brno University of Technology.