Little Pumpkins Set

Set of pumpkins, with and without a face, with an optional cap
~4,5cm in diameter and height (with a cap)

---

It was made with simplified idea from my Little Cactus Set. Check it out :)

---

Short animation from my instagram:
https://www.instagram.com/p/CjSltEcNE97/

---

Base models can be printed in vase mode
Cap can be used only with vase mode or 1 wall prints of a base
It can be used as a surprise box with small toy or candy then
Cap may not hold the base model when resized but still should work

You can resize a pumpkin to use as a candle cover (led candle recommended but tealight may work too without damaging the print - not tested tho)  or even as a bowl for candies
See photos with 200% size, led candle inside (cover photo and 6 last photos)

---

3 bigger, highier quality models, only for printing in vase mode (no top part and no cap model) are here:
https://www.printables.com/model/286381-pumpkin-vases

---

Check my other models in Toys collection:
https://www.printables.com/social/234762-c47_3d/collections/142262

---

Base models were prepared and optimized for printing in vase mode with 0.4mm nozzle
0.1mm layer height
No supports needed

200% size printed with the same settings for vase mode

Cap can be printed without bottom layers if you want to use less filament
Need some infill - I printed it with 15% gyroid
If you resize the cap it may need additional supports on the rim

Print the top part of full model and top part of a cap slowly

---