October 6, 2022
Description
While the C510 webcam is great if you want to put it on the top of your monitor, it's terrible for sitting on a flat surface, It constantly moves and pivots around unless you weigh it down. So I designed this stand which the folded up base of the webcam fits into nicely and keeps it relatively stationary. Underneath, the two channels are designed to hold pens/laser pointers, which also double as ballast to keep the stand from moving around.
The bottom of the top of the stand is a pretty large bridged area, most likely the entire first layer will fail to print correctly, but the following layers should be just fine. After printing just remove all the failed filaments. (That's what I had to do and now you can't even tell)
Category: ComputerLicense:
Creative Commons — Attribution — Share Alike