TS100 Stand Form

This is a form to bend a 2.5-3mm wire into a coil as a stand for a ts100 or similar soldering iron. I used a cloths hanger, but sanded the paint off first so the hot iron wouldn't burn it.

After forming the end can be cut with a hacksaw to make unscrewing it easier. The offset top makes it harder to unscrew without deforming. You could try cutting it apart before unscrewing. I may post a two piece design if there are any requests.

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

2.8

Infill:

Notes:

at least 3 perimeters and 30% infill to make it stiff enough. I used PLA, but anything should work.

Category: Electronics