Dust sensor case (@airrohr) M3 only

I modified the holes to be M3 only, because that's what I have and what I like to use.

The NodeMCU might require to enlarge the holes a little bit with a drill, but I tried and you can also use M3 as is.

In my case, I didn't want to have a loose-jumper cables-setup so I chose to put some headers on a piece of perfboard and use the cable that came with the SDS011 so it's plug-and-play, more error-resistant (no cables falling out or something) while still not requiring soldering the ESP board into the project so it can be reused.

I then put a large enough hole into the perfboard and that's my setup.

I'm not too sure if the rest of the project uses any M2 screws, if it does I will modify those files and upload them here as well!

Print Settings

Rafts:

No

Supports:

Resolution:

0.15

Infill:

Category: Electronics