Low Voltage Switch Enclosure

This is an enclosure for a small direct current light switch that I installed in a shed. It is used to control ceiling lights off a battery.

It prints fast (without supports) and needs a bit of hardware:

• 2 x M2.5 8mm screws
• 2 x M2.5 threaded inserts
• 2 x PG7 cable glands (example reference)
• 1 x JR 12635 switch (exact reference)
• 2 x wood screws (to attach the enclosure to a stud or similar)

Because the shed is uninsulated and is also partially a greenhouse, I used PETG instead of PLA but PLA would be adequate in environment where high temperature is not a concern.