Bottle Opener (Smart Infill)

My mother had some problems to open a bottle. So I asked her if I should print a little helper and without a second to think about it the answer was: "Yes".
So I did a quick search and I found some tools. I showed them to her and she picked this (https://www.thingiverse.com/thing:2801157).
I read through the comments and I was a little bit worried because of breaking the thing and I didn't wanted to print it at 100% infill. I remembered this video https://www.youtube.com/watch?v=q0YsC53mFvY&t=201s and I've quickly redrawn the bottle opener in Fusion 360, configured the simulation and 45 minutes later I started the print.

And right now I've to say, that everything worked out fine.

Print instructions

Resolution: 0.2 or better
Infill: % gyroid for the main part and 100% rectangular for the modifier (simulated part)

This video shows how you can load the smart infill as a modifier in Slicer Prusa Edition https://screencast.autodesk.com/Embed/Timeline/e95bdda6-b4dc-49ba-953a-5e85ff1b5c35