February 18, 2023
Description
Voron v0.1 is built to such tight tolerances. If there is a spec of dust on the table under the z-axis motor, it will make the whole printer wobble. The solution is to move the printer higher off the surface. These replacement little rubber feet use the same 40mm screws as the original, but are 4mm longer to give more clearance to objects under the printer.
Print very slowly in medium hardness TPU (95A). Avoid stringing by printing them one at a time.
Add an M3 washer inside before securing them to the base of the printer.
License:
Creative Commons — Public Domain
7
Steve Hanov
