Rockwell Jawhorse Replacement Jaw

This is a replacement for the urethane jaws that came with the Rockwell Jawhorse. Replacement jaws were extraordinarily expensive when they could be found. It was almost cheaper to buy a new Jawhorse.

This model is based on the following:

Rockwell Jawhorse Replacement Jaw (http://www.thingiverse.com/thing:3411940) by Zeru is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
http://creativecommons.org/licenses/by-nc-sa/3.0/

The model was regenerated in Fusion360 and the CAD file is provided. The model has been modified to be closer to the original vise jaws that came with the Jawhorse - there are nubs on the back of the pad which fit into the holes on the Jawhorse vise.

The model can be printed without supports face-down. There are thin layers inside the holes which must be cut or punched out. A material with some flexibility should be used to print the model - PLA and PETG are too hard. I used NinjaFlex TPU with infill and the pads are very soft.