The very First Print

TL;DR

Single layer whole print bed, see how good or bad it comes out, no change to hide anything.

Collection

tools, 3D printing

update 2026.0221

• added Prusa Core One 250x220

• added Bambulab H2S 340x320

• added Sovol SV08MAX 500x500

update 2023.0613

• added 3mf config file for Prusa Mini 

update 2023.0226

• added 3mf for bambustudio

• cleaned up the description

Let's get started

Full Print Bed

This nice model is useful to check and improve the leveling of your whole print bed. It is not a first layer calibration. You should run the first layer calibration first and use this model to check your whole plate.

If you find in your print areas where the lines are not connected or the print is not well bond to the bed you have a lot of options.

• level your bed

• clean the print bed with IPA or what needed

• use a thicker first layer

• use a higher extrusion wide for the first layer

• print the first layer slower

• print the first layer hotter

Other issues

Burned pieces, scratched pieces any kind of over extrusion.

Go one step forward and run the first layer calibration first.

Attribution

© yahbluez

Can I sell copies of this?

Yes! Yahbluez shared this project under the GNU GPL v3.0 license. This license allows selling copies, but you must provide proper attribution and use the GPL 3.0 license, as detailed in the GPL v3.0 license itself. You have not the right to use any other licence than GNU GPL 3.0.

Donation

If you like to donate you can buy me a coffee

Filament used

works with any filament