Cascade card wallet with magnetic cover

I loved the original model very much but then over time the cards were loosing their grip (I printed in PLA).

So made a cover and few holes to glue in some 3X2 mm magnets (12 count). Use little glue with spray on hardener for a firm bond.

The cover slides on and latches magnetically for satisfying and secure hold.

Magnet can be obtained from amazon and here is the link to what I used

NOTE: 

1. Please pay attention while gluing the magnets ensuring the magnetic polarity. once glued they wont come off.
2. Also note that magnet can interfere with the magnetic strip on the card but I have seen enough videos around this and have used mine for a few weeks now without any issue. Also most cards are these days chip bases so it should not be a problem.

Thanks to Hugo for the wonderful and inspiring original design.