Ender 3 FreeABL Direct Drive

This works with stock Ender 3 parts, however, I recommend making or buying a longer E stepper cable, 2 meters (1.5m is too short for nice cable management). For instructions on FreeABL, please visit Thingiverse and Reddit for proper instructions. A firmware flash will be needed to enable mesh bed leveling with a manual sensor.\

This part can be used for direct drive conversion without FreeABL if desired.

Print instructions

Supports are needed, print with 40% infill with .16 resolution or higher. (.22 will not be strong enough over time)