Protusion from original Voron 0 spool holder is getting in the way? Too much work to remove it and leave 1 nut hanging loose inside the frame?
Then you'll need this Voron 0 Foldable Spool Holder!
Features
Keeping the dimension & look of original spool holder as much as possible. (This means you can re-use the PTFE tube from the original spool holder)
Foldable, reducing the overall dimension of Voron 0 for easy storing / traveling.
Compatible with any acrylic panel thickness less than 3 mm.
Easy 2-part assembly.
Assembly Instruction
Print Instruction:
Support (Touching BuildPlate) may be required for “Connector_V0”. No support required for “Holder_V0”.
Recommended to print in default orientation.
Recommended print setting:
ABS / PETG
40% Infill
Wall Count: 3
Top / Bottom Layer: Minimum 4
Parts Required:
M3 x 35 SHCS / BHCS Screw x 1
M3 x 10 SHCS / BHCS Screw x 1
PTFE Tube x 2 (tubes from original spool holder is usable)
[Printed Part] Connector_V0 x 1
[Printed Part] Holder_V0 x 1
Assembly:
Remove the original spool holder. You can keep the original M3 x 12 screw, it will not be used in this assembly.
Secure the “Connector_V0” onto the frame using M3 x 10. Note: Make sure that the fillet (rounded edge) is facing the acrylic!
Insert PTFE tube x2 into “Holder_V0”.
Place “Holder_V0” towards the “Connector_V0”. Then, use M3 x 35 as a shaft to connect the 2 parts. Do not overtighten the screw! Note: Make sure the fillet (rounded edge) of “Holder_V0” is facing acrylic too. Note: Make sure the countersunk on “Holder_V0” is facing upwards.
Finally, tighten the M3 x 35 screw slightly until the folding operation of the spool holder will hold itself by slight friction (so it won't swing free and slaps around when carrying you printer!) Note: Seriously, don't overtighten the screw. It may not able to fold.
Enjoy!
Note: Made to support Voron 0.1, however should be able to support voron 0.2 as well.
Kai
