November 15, 2022
Description
This is my version of a Fruit Bowl. Its a little different than a normal one.
The bowl has a base with six arms and six nets in between.
On the top and bottom of each arm is a hole for hanging the bowl or even two or three of them on top of each other.
The bowl is very stable. The nets are pushed into the arms from above. Then the arms with the attached nets are inserted into the base plate. Holds up very well.
Hereis a little guide to put it together:
You dont need any screws or glue to put all parts together.
The bowl is 29cm wide and 15cm deep.
I used PETG transparent green for the base and the arms. The nets are made of transparent TPU.
I printed the PETG part with a 0,6 nozzle and the TPU nets with a 0,4 nozzle. Infill 20-25% should be good.
Hope you like it.
Enjoy
License:
Creative Commons — Attribution — Noncommercial
Flotschi
