Galaxy Watch Charging Stand

Samsung abandoned the charging stand for some reason and with recent watches delivers a small puck shaped magnetic charger. This can be annoying with some styles of watch straps so I made a simple stand to hold the charger.

Print the stand as it is in the STL, on it's side and no supports are needed. I printed mine at 0.2 mm layer height and all the dimensions fit well. The charger is a tight fit, so it does not come out of the stand when the watch is taken off.

I tested the stand with a Galaxy Watch 5 Pro (45 mm) and the 40 mm version, so it should work with all the watches that come with the same magnetic charger.

Since the fit of the charger is tight, once you insert it it's kind of semi-permanent, it can be difficult to get out. I added a second model with a hole in the back which can be used to push the charger out.

Update 06.12.2022.:

Added a third model with the charge hole diameter of 33.75 mm, the original is 30 mm which fits the charging pucks I received with my Galaxy Watch5's. Also made the hole deeper, at 9 mm. I did not test the fit of this new model, if you make it please leave feedback.

Update 08.12.2022.:

The model with the hole that fits the bigger charger has been tested by Reeperru. Thank you again for feedback.

Update 06.07.2023.:

Added two more models, which are taller versions of the 30 and 33 mm models with the removal hole. They are 4 cm taller, so now there should be no interference between the base and the watch strap. I printed a couple and they are still stable and do not topple over when the watch is placed on them. Let me know if 4 cm is too much or just right.

Updated 07.08.2023.:

Galaxy Watch 6 chargers seem to fit as well, kindly confirmed by WaX3DP in the comments.