Shower holder (adjustable to any direction)

This is a highly redesigned remix of Shower Holder with swivel adjustment
by owsam3dprint (May 04, 2018, https://www.thingiverse.com/thing:2892895). I like the idea of the ball joint but I don't like the direction that shower holder points to (mainly to the side and not to the bottom). This is why I made the base with 15 degrees slope that can point the shower both to the bottom and to the sides. I also made the distance between the holes 50 mm as I already had these holes in the wall left from the previous shower holder.

Print settings.

I used PETG with 4 walls and 40% infill for all the parts. But it is very important to print the petals of the ball joint with 100% infill, otherwise you will break them when you try to insert the ball inside (it goes in rather hard). The easiest way in Cura to make 100% infill for the petals and leave 40% infill for the rest of the base is to use a cylinder rotated 15 degrees and positioned over the petals, starting 2-3 mm below their bottom. Then set "Per model settings" - "Modify settings for overlaps" and set "Bottom layers" to 999.

I recommend to push the ball when the nut is slightly screwed to the petals, this will decrease the possibility to break them by bending too far to the sides.

Print only one base that you like - with square or rectangular corners depending on the style of your shower cabin or personal preference.

Holder needs support, other parts don't.
Nut should be printed upside-down (rotate it 180 degrees in Cura).

Cap is optional, print 2 of them if needed. They are used to protect bolts from rust and also for decorative purposes.

Spacer is optional, it is only printed if your shower sits too loosely in the holder. I glued it with hot glue gun because hot glue is easy to unglue and remove later in case I buy a thicker shower in the future.

Enjoy!