Camera Tripod Nut Mount for Prusa Box

This model is designed to position a 1/4-20 (camera) nut inside the Prusa-Box, facing the center of the heated bed. This allows attaching any articulated arm that has a standard tripod screw mount. I'm using it with a SmallRig articulated arm, but any standard camera rig should fit.

Hardware Required:

• 1/4-20 nut (1/4", coarse thread, i.e. tripod nut)
• 2x m4 nuts
• 2x m4 screws, 6mm or longer

Installation:

1. Make sure the large hole for the 1/4-20 nut is clear of debris - it will be difficult to remove later.
2. Insert the 1/4-20 nut into the large hole. It is a tight fit so will require some pressure. You can use a hex key to lever the nut into place.
3. Insert two m4 nuts into the hex-shaped depressions.
4. Secure the mount to the front-left corner of the Prusa-Box using the two m4 screws.