I've seen great model from Simple3D so i remixed it and added container for silica gel to it. For it to better hold i also added one 5mm hole for screw. I made it so that you can print it on the Prusa Mini if you rotate it 45 degrees, so that it is diagonal.
Printing
- Print on the side, so that the container can print easily
- You can add supports to the hole for the sensor, but its not necessary
- Add pause print before it blocks the container. If you are printing on 0.2mm then it will be on 38.2mm - layer 191.
- When it pauses place the silica gel inside it (either you can put it with the wrapper or pour out the content of it)
Post processing
- Place the sensor to the hole
- You'll need to cut another hole to the dryer.
- Attach one side to the pre-made hole and draw a dot where you'll need to make the another hole
- Drill a 5mm hole and attach it on the other side
HelloItsMeAdm
