June 6, 2020
Description
Wanted a top plate for my portapack. This also puts bumpers on the sides of the display, hopefully keeping something from cracking the screen.
Oh! Just noticed it's sitting up on edge. Lay it down flat so you can actually print it! Though you get cool points if you can print it as is with no support!
The guys that make it possible.
https://twitter.com/sharebrained/
https://twitter.com/michaelossmann
Post-Printing
It's a snug fit, I modeled it off the cad file for the circuit board. With the first layer squish you'll need to file the bottom edge a bit. I also found I had to ream out the screw holes a little, I think my scaling is off a touch.
Lay it down flat to print, no supports needed!
License:
Creative Commons — Attribution
Barry
