Edelbrock 1806/1906 Duct Intake

One of the first things I wanted to upgraded on my Chevrolet Monte Carlo '76. Was the intake filter system, as well as using my 3D printer for a car project.

So I came up with this design, not optimal in terms of it sucking the hot engine bay air in and through the engine, But a good first project and mechanical and thermal test of 3d printed parts.

The filter part consists of a 5mm thick alu plate and above it goes a hand cut filter material of your own choosing. I had an abundance of fine meshed plastic sheet filter material at my work, so I choosed that.

Similar to this;

https://duckduckgo.com/?q=filter+material+mesh&atb=v316-1&iax=images&ia=images

The filament material to be used should be either of these materials, to prevent melting of the 3d printed parts;

Polycarbonate
CARBONX™ PC+CF
CARBONX™ PA6+CF
PAHT CF15

Or similar filaments, not PLA, PETG or ABS. They will melt eventually!

If you encounter a problem, leave a comment down below.