Prusa Enclosure "Stay-Open" Hinge

This uses the same hardware as the original hinge, but adds magnets on each hinge.  This adds just enough force to keep the door open while working on the printer so the door doesn't close on your arms, head, etc.

Assembly instructions:

1.  Print 4 each of the enclosure hinge and the door hinge assemblies.
2.  Remove the old hinges from the door and the enclosure.
3.  Retrieve the pins from the old hinges as you'll need these for the new hinges. (this can be done by cutting the thinnest part of the hinge bracket that attaches to the enclosure and then using pliers to pull the hinge pins out).
4. Put a drop of superglue in each of the three holes for the magnets.
5. Slide in a 2x6x20mm magnet in each of the slots.
6. Reassemble the new hinges and attach to the enclosure.

I printed this in Prusament PETG with a 0.4mm nozzle and a 0.2mm layer height on the satin sheet. 

The 2x6x20mm magnets can be purchased here: 

Amazon:

https://www.amazon.com/Rectangular-Neodymium-Refrigerator-Industrial-N35/dp/B0B689HC3S/

Aliexpress:

https://www.aliexpress.com/i/2251832681412631.html