December 7, 2022
Description
Not sure if it was just the cleaners I was using on my counter, but the feet of my sealer would smear rubber wherever it was used. Hello, 3d printer. This is a set of replacement feet for just about any Impulse Sealer on the market. It works for Harvest Right, ULine, and with my cheap knock-off sealer. You may need to increase the inner screw hole size as all my units were different, but just scaling the whole model will work since the overall height and width of the feet really do not matter.
I used TPU for Non-Slip. .2 or .3 and 10% fill works fine.
After installation, be sure to place your sealer on a flat surface and adjust individual feet to ensure the unit is level.
No more streaks! Sorry Magic Eraser, back in the closet with you.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Pyroduck
