December 8, 2022
Description
My Printer:
- Ender 3 v2 with Bigtreetech skr mini e3v3 motherboard (option: Bigtreetech DCDC5V V1.0 Module)
Print tips;
Do not put any support around 2mm thread holes.
What you need;
- Adafruit Neopixel Stick x2 NeoPixel Stick
- 380-400 Ohm resistor
- 1000uF Capacitor
- Ribbon cable (approx. 50cm)
- JST-XH (3 pin) connector and terminals
- M3 8mm bolt x2
- M3 T nut x2
- M2 8mm bolt x6
Post print;
Using the attached template (print on A4 paper), solder Neopixel Sticks, wires, resistor, capacitor and place it in the the case. Attach the case below the 2020 frame with T nuts. You need to reduce maximam z heighth by 20mm.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
7
Tomoaki Shimazu
