Small Christmas Balls

These are 40mm ball ornaments, intended for resin printing.  Ball walls are approximately 1mm thick.  There are three versions, coarse facets (#1), fine facets (#2) and smooth (#3).   There is a 2mm vent hole at the base of the ball.  Print with the base orientated towards the build plate and slightly elevated to keep the vent open.  3 rings of medium supports, starting just outside the vent hole should be adequate for printing.   

I reduced these to 95% size to fit six on the build plate of my Qidi 6.08 mono.  Print time for that printer was a bit over 2 hours.