S-biner locking slider

I use a Nite-Ize #3 locking S-biner on my keychain, and one of the little plastic locking slider pieces went missing. Rather than buy a whole new carabiner, I designed and printed a couple of these replacement sliders. It's slightly beefier than the original, in an attempt to make it fit more snugly in the locked position.

I printed it in generic PETG with 0.1mm layer height, 250 degree nozzle temperature, and enough perimeters to make it solid. I used a brim because there's not a ton of contact area, and it took about 9 minutes to print.