Klipsch R-25C Center Channel Speaker Wall Mount

Updated 2017feb07: v1.0.1 fixes some calcs that prevented increasing mount tab beefiness, plus beefed it up from 3mm to 4.3mm just to be sure (plastic is cheap !). v1.0.0 models are still there for comparison but suggest to just go for the big'n. My original is still holding just like in the picture above, but one other person had theirs separate (although that could have been their print settings). Full details below...

// model: Klipsch R-25C Center Channel Speaker Wall Mount
// author: [email protected]
// date: 2017feb07
// ver: 1.0.1
// notes: Uses original speaker terminal mounting screws so no alterations to the speaker are required
// history:
// -1.0.1 - 2017feb07 - Fixed incorrect calculation that resulted in mountingTab being thinner than expected
// - Increased mountingTabThickness from default 3 to 4.3 to ensure adequate strength when
// installing with long mounting screw (to get it to angle downward) which could pull
// layers apart from the unexpected increased horizontal load
// -1.0.0 - 2015jul11 - Released

Print instructions

Unassociated tags: center channel, wall mount

Category: Audio Summary

Updated 2017feb07: v1.0.1 fixes some calcs that prevented increasing mount tab beefiness, plus beefed it up from 3mm to 4.3mm just to be sure (plastic is cheap !). v1.0.0 models are still there for comparison but suggest to just go for the big'n. My original is still holding just like in the picture above, but one other person had theirs separate (although that could have been their print settings). Full details below...

// model: Klipsch R-25C Center Channel Speaker Wall Mount
// author: [email protected]
// date: 2017feb07
// ver: 1.0.1
// notes: Uses original speaker terminal mounting screws so no alterations to the speaker are required
// history:
// -1.0.1 - 2017feb07 - Fixed incorrect calculation that resulted in mountingTab being thinner than expected
// - Increased mountingTabThickness from default 3 to 4.3 to ensure adequate strength when
// installing with long mounting screw (to get it to angle downward) which could pull
// layers apart from the unexpected increased horizontal load
// -1.0.0 - 2015jul11 - Released

Print Settings

Printer Brand: Printrbot

Printer: Simple White

Rafts: Doesn't Matter

Supports: Yes

Infill: 100%

Notes:

If printing taperred, suggest 100 micron and 200 micron for flat version.

Enable supports everywhere then scrape them out through the screwHeadHole

If using Simplify3D, set support resolution of 2mm and preview to ensure support is oriented at right angle to the screw slot. If it isn't, change Support Infill Angle value by 90 deg (default is 0).