Printrbot Simple 1405 Fan Shroud for E3D v6 Hotend

This fan shroud is optimised for use on the Prinrbot Simple 1405 with an E3D v6 Hotend. In theory it also works with the Ubis, however I can not guarantee, that it lines up correctly.

There is a normal version (redone) available that works on the same principle as the original printrbot-shroud.

The other version (redone deflector) has a ring of material that goes all the way around the hotend. It doesn't look like much, but I have found that this makes quite a dramatic difference in airflow direction. It even prints without supports; thats tested with the cheapest PLA that was available.

Just watch out, when heating your bed above ~60°C with the hotend close to it and the cooling fan not running, the deflector might sag down onto the bed.

For a more advanced, omnidirectional version, check out this thing: http://www.thingiverse.com/thing:655807

Category: 3D Printer Accessories