December 16, 2022
Description
Wasn´t available to buy, so I had to design it myself.
It works great without any wobble and it even looks great after sanding it down with 1000 grid sandpaper and water. I used PLA+ from eSun, but ASA might be the better choice if you have it and can print it!
Attention: It can NOT be scaled up or down!
Printer:
Sovol SV05
Rafts:
No
Supports:
No
Resolution:
0,15
Infill:
100%
Filament:
eSun PLA+Cool White
Notes:
Print as hot as you can to good layer adhesion (with my printer and the eSun PLA+ that was 230°C)
You need to print it upside down, so on the nose to avoid supports! But that requires a brim as the contact area to the buildplate would be too small otherwise.License:
Creative Commons — Attribution — Noncommercial
9
PcDoc
