TastyDonut Cookie Cutter

It's the time to make tasty treats and you can't decide whether to go out for a donut or stay in and bake cookies. The advantage of baking cookies is the aroma that fills the house while the advantage of a donut is… well… it's a donut. Why not have both at the same time? Introducing the Donut Cookie Cutter. This cutter has been optimized with 3° draft where possible to aid in cookie removal. The design also sports a hole for hanging with all your other cookie templates. Please excuse the bite already taken out of your cookies. The printer was getting hungry. 

Print Time: 1hr 17min

Estimated cost: $0.50

Cookie Diameter: This cutter makes 70mm (2.75in) cookies

Cookie Thickness: To reach proper press distance dough must be rolled to a thickness of approximately 12 mm (0.5in)

Printing is best done in PLA at 20% infill, 0.3mm draft print settings. I also used the glue stick since the PLA doesn't like to stay on the bed.

Within the code, you will be sung Megalovania from Undertale to designate when the bed is hot enough to operate. Upon completion of the print, a Mario Coin collection will sound.

Please note: Lines 382 and 383 have been commented out to allow gcode to be published and provide data into Printables.com. There is a .txt file below as well to allow for save as gcode without requiring a program edit.

AND REMEMBER: ALWAYS CLEAN YOUR PLATE

(Valuable lesson, Play Dough and Glue Stick don't work too well together)