January 7, 2024
Description
--V1.2--
Added _TS for those who wants to print without corner brims and smaller spindle to accommodate wire spools with smaller internal diameter.
--V1.1--
Adjusted fittings of conical ends to the spindle.
--V1--
Too many wire spools, needed a way to organise and label them. Plus I wanted to try out some fitting techniques.
All the parts snap/slide fit together.
--Open to suggestions!--
Optimised
0.3mm layer height, 4 top and bottom layers
2/3 Shell, 5% infill
Support from built plate only, enable bridging.
Brim not recommended
~85g of PLA used
or whatever settings you are comfortable with
License:
Creative Commons — Attribution — Noncommercial
8
Jay
