BULLET BILL / BANZAI BILL

"After reading the comments on Joel Tellings video I realised that a lot of people were saying this model should actually be called BANZAI BILL.  Most people don't seem to mind but I had a few spare minutes so I've now added another base which says BANZAI so you can choose which one to use.    

The models has been separated into parts which should hold together without the need for glue.  

You will need to turn support on for the teeth but the rest will print ok without it.  I would advise printing at 150microns or lower so that the screw threads come out nice and tidy.

When assembling, push the red insert almost all of the way in but stop a few mm's short so that you can insert the pre-assembled eyes through the holes, then when you push the red insert in fully the eyes will be held in place without the need for glue. 

Then just screw the base on to hold everything in place,  if the thread is tight you may need to work the thread in out out until it frees up. 

Any questions just let me know. 

Martin"

ORIGINAL: 3D Printable BULLET BILL / BANZAI BILL by Martin Moore (myminifactory.com)