Voronoi Soap Dish

Yet another soap dish. Features an inclined bottom to make any excess water flow out.

Printing

Material: Doesn't really matter. Go with what you like.

Support: None. The updated shell does not require any support. The original shell (not recommended anymore) does need some support for the lower parts of the fillet.

Infill: No special requirements. Use the minimum amount that is needed to support the top layers.

Perimeters: That's up to your preferences. I personally recommend 3 perimeters to get some durability.

Orientation: I strongly recommend to print the tray upside down. This will give you a much nicer visible surface finish. The shell must be printed bottom down, as it is, obviously.

Changelog

Update 1

As @Faasteer_549552 pointed out in his remix, the overhangs of the rounded edges of the original design are a pain to print. I've added an updated shell where the overhangs are reduced to a maximum of 45°. In my experience that should always print cleanly without support.

Update 2

The tray snaps now into the shell.