December 30, 2022
Description
My goal was to design a CalDigit TS4/3 under desk mount that would fit my needs:
When mounting the two halves you should be mindful of the fitment around the dock which is quite critical, for this reason I chose to use 3M VHB tape rather than screwing to my desk. A close fit will ensure that the tabs can adequately hold the dock in place but still be able to flex out of the way when enough force is applied.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Resolution:
0.28
Infill:
20
Filament:
eSUN PLA+Grey
Notes:
3 perimeter walls recommended for rigidity, 20% infill works fine, but you could consider 100% (solid) for a really solid mount.
Print in vertical orientation with tabs at the top.No supports should be necessary as hexagon overhangs should print with adequate part cooling.
License:
Creative Commons — Attribution — Noncommercial
Calomile
