beagle camera arm

can be mounted high or low on vertical or horizontal on 3030 aluminium profile with no t-nuts.

base is 2 parts, put 1x m5 nut (6k 8x4mm, DIN 934) and use e m5x14 to tight base 1 when its in place in profile (designed with 2 screws but established that one was enough to hold it)

for the camera mount you need end, end 2, and 2x end 3. if holes for the taps is to tight you might have to gentle drill them out little with 5mm drill and the tighten it up with m5x35 and m5 nut

and  between them you can compose arm configuration you need for your camera, for tightening use M6x35 and M6x40 and m6 nuts with 10mm key width  and if you want it tool free print some M6 wing screws

and there is a universal mount to with 6,2mm hole to screw some other fastener on it