January 2, 2023
Description
A quick print for an SD card holder located at the bottom front of the Ender 3. Can hold an SD card and a micro-SD card. I did not feel the need to add any more slots than this. I only use a single SD card for everything I make with my printer. 32 GB is more than enough for me!
Uses existing screws on the Ender 3. You only need to remove the two screws and insert them back in the same threaded holes.
Enjoy!
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
Yes
Resolution:
Standard
Infill:
18%
Filament: AMZ3D PLA Lake Blue
Notes:
Printed vertically with rafts and supports. With bolt holes on the left and SD card slots on the top. So basically printed in the same orientation as it was installed.
The raft keeps the part stable during the print. The supports do their job and are very easy to remove by poking through the holes.The print took about 2 hours and 35 minutes. Printed on the original heated bed that comes with the Ender 3.
License:
Creative Commons — Attribution
7
Popcorn
