Lenovo Tab M10 wall mount

I have a Lenovo Tab M10 that I want to use for a home automation dashboard, where I mount it securely on a wall.

I designed this mounting option to have the following features:

• Fully enclosed to aid in theft prevention.
  • Mounting screws inaccessible once fully assembled.
• Integrated power via pogo-pin power connector (3.5mm spacing).
• Full access to volume and power buttons.
• Hex-pattern back plate for good combination of strength vs. filament usage (also helps keep the tablet cooler)

While the power connector is technically optional, if you want to keep it powered then your will need to source one.

The power connector only fits one-way, this is because the tablet has requirement for which pin is positive and which is neutral.

The mount itself has hole for the power cable to pass out at the bottom (landscape orientation) or to the back (if you want to feed the cable through the wall to hide the cable completely)

The front cover is a tight snap fit, I suggest snapping on the left or right side first, and then doing the other.

The Connecting Plate is designed to be printed without supports, as the internal hole has been designed to print in bridge steps similar to how Prusa designs screw holes in their models.

All other model files are printable without supports as well, as there are no overhangs steeper than 45 degrees.

I suggest using a bit of tape to hold the buttons in place when assembling it all.

---

I have included STEP files if anyone needs to make changes/remix for other tablets or features.