Ender 2 Pro Satsana with Stock Fans

This is a Satsana "inspired" design for the Ender-2 with the stock fan duct and CRTouch/BLTouch mount.  (CRTouch/BLTouch is optional and doesn't need to be installed.)  Designed to be printed without needing supports.

This should allow for full travel of the bed without any mods for that.

Nozzle offsets should be
CRTouch: {-40.5, -21, 0}
BLTouch: {-43.5, -22.5, 0}

(Note: Since I do not have the stock fan setup, I cannot test this.   If you have problems with it, please let me know.)

Some notes on the logic behind some of the design decisions that are a bit different from original Satsana design:

Smaller gaps on the bottom of heatsink to prevent unwanted airflow from heatsink fan. (Better for PETG/ABS printing.)

Air gaps on the side are angled upward to direct heatsink airflow away from part.

Larger area between heatsink and wires to allow to print without a brim.

Larger gap between heatblock and air ducts to prevent melting at higher temps. (Mostly happens on the right side where the silicone is not on the wires.)