January 8, 2023
Description
I found most of the racks around use dowl rods and while I already had some wood strips around, I modelled this up for them.
Wood lengths can be as long as you like! But need to be 9mm x 33mm (0.35 x 1.3in) at the end for the brackets.
Bracket is mounted to the wall by 1 screw on each end, screw hole being 4mm and has a neat little cover to hide the screw head after fitting.
The 2 upright slats are captive while the lower one rests in a groove. There are holes for small M3 grubscrews to go into the back if you with to secure the lower wooden piece :)
Prints fine without supports. Printed here in Silk Gold PLA+.
Max pot/jar diameter 50mm.
License:
Creative Commons — Attribution — Noncommercial
E For Extrude
